The penis is divided into three chambers. There are two large ones at the top which is the erectile tissue (Corpora Cavernosa) and one smaller chamber at the base from which ejaculation and urination occurs (Corpus Spongisum).

When an erection happens the brain releases a hormone that sends blood to the penis, filling the Corpora Cavernosa. The blood spaces within the Corpora Cavernosa fill to the maximum causing the erection.

The Bathmate® develops the Corpora Cavernosa, making it larger and stronger, therefore increasing the potential size of erection.

The pump gaiter design forces are calculated to allow a minimal compression force whilst achieving maximum expansion force, allowing maximum growth with minimum discomfort.

The more that water is forced from the product the more the penis is forced to expand and the higher the hydro force vacuum becomes within

The penis is not in an erective state before of after using the product; however the product does simulate the blood flow that would be found in a natural erection. Bathmate® seals on the base of the penis, not two to three inches up, and therefore ensures that blood flow affects the whole penis and not just the end.

Using Bathmate in the bathtub

   1.  Fill the bath with water

   2. Once your in the bath put the Bathmate under the water until it completely fills full of water, then whilst it is under the water put your penis inside it.

   3. Push the bathmate down towards the pelvis area several times until you create a vaccum. You should start to feel the pressure building up. Surplus water starts to be realeased from the pressure release valve at the top of the bathmate. You may have to pump it down four of five times until no more water comes out the pressure release valve.

   4. Once you cannot pump down any further just relax for 5 mins. Whenever you cannot pump the Bathmate down any further this is the optimum vaccum at that particular time.

   5. Every 4 or 5 minutes try pump down again. As your penis is expanding this will force excess water from the top of the Bathmate everytime you pump down. But you will always reach a point where you cannot get any more pump.

   6. Pump the Bathmate to its optimum vaccum when you feel necessary. This is the stage where no more water comes out the end when you try pump down.

   7. If you feel the pressure is too much just lightly press the pressure release at the top of the Bathmate. This will release pressure. After 15 to 20 minutes release the pressure by pressing the pressure release at the top of the Bathmate and take the unit off.

   8. We recommend between 15 to 20 minutes per session.
   9. Use the unit as often as once a day but no less than three times a week for best results.

Using Bathmate in the Shower

1. Fill the bathmate with water from the shower

2. Hold the bottom of the bathmate to ensure water does not escape.

3. Place the penis inside the bathmate and push towards the body to create an air lock.

4. Continue your shower, remove hands to wash. Increase pressure
by pumping further if required.

5. After 15 minutes press the release valve at the end of the
bathmate to release.